Utilitech 00761 Manual De Instrucciones página 16

EXISTING CONSTRUCTION (BELOW CEILING APPLICATION) INSTALLATION INSTRUCTIONS
2. Insert the housing (A) at an angle through the ceiling
opening and temporarily place the housing (A) above
the existing ceiling.
Note: For access from below installation, you must have
at least 9 in. of clearance between sub floor and
ceiling for the fan's chassis to fit properly.
3. Insert the existing wires from the installation location
through the punch-out hole on the housing (A).
4. Connect the round ductwork (not included) to the duct
adaptor (D) and secure with duct tape (not included) or
clamps (not included). Then attach the duct adaptor
(D) to the housing (A) by inserting the hooks of the duct
adaptor (D) into the slots on the housing (A), and using
the duct adaptor screw (II), tighten the duct adaptor
screw (II) securely.
Hardware Used
0
Duct Adaptor Screw
()II
X
1
16
r
punch-out hole
. G
_
~ot
+ - n B hook
~ ~(C---
- - - - 0
"""' ?
I :1
~~
I :I
9
~jlj~
--
.,
~ ---ra
'/
• I
~
I
~UTILITECH"
J
Lowes .com
\:1 - · -