Idiomas disponibles
Idiomas disponibles
English
1) Safety
The unit radiates RF energy in transmitting mode. To reduce the exposure to the
lowest possible value and to benefit the most of the set's features, keep the fol-
lowing in mind:
In transmission mode, keep the unit in a vertical position at a distance of 2
inches away from your face. Keep the antenna at a distance of at least 3 inch
away from your head and your body. If you are carrying the unit at the body,
make sure that the antenna keeps a minimum distance of 3 inch to your body
in transmit mode.
2) Service
The condition of the accumulator must be tested from time to time. If the accu-
mulator is weak a short time after complete charge, it should be removed from
the set. It can leak and damage the device. Replace it by a new one.
Worn out accumulators do not belong into the waste bin, but must be returned
to a suitable collecting depot or to a special dealer, for the sake of the environ-
ment.
There are no user-adjustable or user-serviceable parts inside the radio. The
casing must not be opened. Independent repairs or adjustments must not be
carried out, since each modification or unauthorised intervention will immedia-
tely cancel all and any guarantee or repair claims, they are also likely to result
in non-conformity to ETS/EN regulations which will render the set to become
illegal.
In the event a defect becoming apparent, contact a properly equipped and aut-
horised TEAM dealer or TEAM directly.
3) Conformity
The transceiver TEAM TeCom-F6 complies with the rules of the European
Directive R&TTE and meets the European Telecommunication Standards
EN 301 189-1 / -2, EN 300 086-1 / -2, EN 60950.
22
General
4) Programmed Channels *
Channel TX-Freq.
TX-Code
RX-Freq.
MHz
CTCSS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
5) Programmed functions *
Insert below the functions that your dealer has programmed into your transceiver.
Scan
: Yes / No
Time-Out-Timer :
ms
Squelch
:
TX-Power
: High / Low
Beep Tone
: Yes / No
Save Battery
: Yes / No
* = For programming the TeCom-F6, the software T-UP9 with the suitable
programming cable is required. Programming should be performed by
experts only in conjunction with the according measuring equipment.
RX-Code
Busy Chan-
Bandwidth
MHz
nel Lockout
narrow / wide
CTCSS
English
23
Capítulos
