IMG STAGELINE LED-10SPOT Manual De Instrucciones página 8

LED Spotlight
These instructions are intended for installers of
the unit and for users with basic knowledge in
DMX control . Please read the instructions care-
fully prior to operation and keep them for later
reference .
1 Applications
This compact spotlight with high power RGBW
LED is used for effect illumination on small
stages, in clubs, party rooms etc . Various oper-
ating modes are available (e . g . automatic show
programs, music control) .
The spotlight is designed for control via a
DMX light controller with DMX512 protocol
(4 or 7 DMX channels), but it can also be oper-
ated without a controller; either as an individual
unit or in combination with several LED-10SPOT
spotlights in master/slave mode .
2 Safety Notes
The units (spotlight and plug-in power supply
unit) correspond to all relevant directives of the
EU and are therefore marked with
WARNING The power supply unit uses danger-
ous mains voltage . Leave servicing
to skilled personnel; inexpert han-
dling may result in electric shock .
•
The units are suitable for indoor use only . Pro-
tect them against dripping water and splash
water, high air humidity and heat (admissible
ambient temperature range: 0 – 40 °C) .
•
Immediately disconnect the power supply unit
from the socket
1 . if the spotlight or the power supply unit is
visibly damaged,
2 . if a defect might have occurred after a unit
was dropped or suffered a similar accident,
3 . if malfunctions occur .
In any case the units must be repaired by
skilled personnel .
•
No guarantee claims for the unit and no lia-
bility for any resulting personal damage or
material damage will be accepted if the unit
(spotlight or power supply unit) is used for
other purposes than originally intended, if it is
not safely installed or not correctly connected /
8
operated, or if it is not repaired in an expert
way .
3 Installation
•
To prevent heat accumulation inside the unit,
always position it in such a way to ensure suf-
ficient air circulation during operation . Never
cover the air vents of the housing .
•
Always keep a minimum distance of 50 cm to
the illuminated surface .
Fasten the spotlight via its mounting bracket,
e . g . with a stable mounting screw on a crossbar .
Release the two locking screws on the bracket,
adjust the spotlight as desired, and then fasten
the screws .
WARNING Install the spotlight safely and ex-
.
4 Operation
WARNING To prevent damage to your eyes,
Connect the low-voltage plug of the power sup-
ply unit provided to the low-voltage jack on the
side of the spotlight . Connect the power sup-
ply unit to a mains socket (230 V/ 50 Hz) . Thus,
the spotlight is switched on, its fan starts run-
ning and the last setting is displayed for approx .
17 seconds .
To switch off the spotlight, disconnect the
power supply unit from the mains .
If the units are to be put out of oper-
ation definitively, take them to a local
recycling plant for a disposal which is
not harmful to the environment .
pertly . When installing it at a place
where people may walk or sit under
it, additionally secure it (e . g . via a
safety rope on the mounting brack-
et; fasten the safety rope in such a
way that the maximum falling dis-
tance of the unit will not exceed
20 cm) .
never look directly into the light
source .
Please note that fast changes in
lighting may trigger epileptic sei-
zures with photosensitive persons
or persons with epilepsy!