18
NOTE:
If you lift the appliance while it is in operation,
the motors switch off automatically after approx-
imately 1 second without floor contact. However,
the appliance is not switched off (the blue LED
is still lit) and starts up again as soon as it makes
contact with a surface.
▶
To switch off the appliance, set ON/OFF switch to
). ➔ The LEDs go out.
position 0 (Fig.
/
11
B
Emptying the dust bin
Ensure that the ON/OFF switch is in position 0
1
(Fig.
/
).
Reach into the recessed grip
11
B
2
(Fig.
7
/
) and unlock the cover of the dust bin
5
(Fig.
/
).
Remove the dust bin comportment
7
1
3
cover (Fig.
/
) from the appliance (Fig.
7
1
Remove (Fig.
15
) the dust bin cover (Fig.
4
Carefully pull dust bin with the attached filter from
5
the appliance (Fig.
).
16
6
filter above a waste bin and then separate dust bin
from filter. Tap both parts lightly and remove coarser
debris with a dry cloth.
Cleaning the dust bin and the filter
Remove and empty the dust bin > "Emptying
1
the dust bin" on page 18.
bin by hand under running cold water or lukewarm
water.
Thoroughly rinse filter by hand under run-
3
ning cold water or lukewarm water.
elements to dry at room temperature for at least 24
hours.
Reinsert filter into dust bin in such a way
5
that the plastic grid of the filter is visible. Firmly push
filter into place (Fig.
17
).
ter into the appliance > "Inserting dust bin and filter"
on page 18.
Inserting dust bin and filter
Reinsert dust bin with attached filter into dust bin
1
compartment (Fig.
).
17
in place until you feel it engage (Fig.
the dust bin compartment cover in place at the front
so that the 3 tabs on the cover engage in the 3 slots
provided in the dust bin compartment. Now press
against the dust bin compartment cover in the rear
until you hear and feel it click in place (Fig.
NOTE:
The appliance can only be switched on again if
the cover is positioned correctly.
).
14
7
/
2
Place dust bin with attached
Thoroughly rinse dust
2
Allow both
4
Reinsert dust bin with fil-
6
Put dust bin cover firmly
2
18
).
First, put
3
).
19
EN
Removing the battery pack
Operate the appliance until the battery pack is
1
completely empty and the motor of the appliance
stops.
Place the ON/OFF switch to position 0
2
(Fig.
/
).
Firmly remove cover from battery
11
B
3
compartment (Fig.
tery pack.
Accessories
• Round brush (2x) – 0606001 (Fig.
• Filter – 0606002 (Fig.
• Rechargeable battery – 607004 (Fig.
• Mains adapter – 0606003 (Fig.
Troubleshooting
Before you contact our customer service department
).
or send the appliance to the Dirt Devil customer ser-
vice department, you will find a lot of additional in-
formation in the service area of our website which
will help you solve problems.
www.dirtdevil.de/service
!
WARNING!
Switch off the appliance before you start trouble-
shooting. Never use a faulty appliance, charger or
rechargeable battery.
5
/OPEN).
Remove the bat-
4
20
/A)
/B)
20
/C)
20
/D)
20