Ratio IN1500 Traducción De Las Intrucciones Originales página 37

2. Connect the machine to power outlet ensure
that the mains cable is clear of the blade and
base plate.
3. Position the material to be cut on the machine
bed, ensure it is firmly held so that it will not
move during cutting.
Ensure that the rotary table locking knob (13)
and bevel lock knob (22) are tightened before
cutting.
4. Press the trigger switch and allow the saw
blade to run up the speed.
5. Still holding in the trigger switch, press the
safety release lever (16) towards the handle. It
will then be possible to push the saw head down
by the handle.
6. Continue to move the saw head down
smoothly and make the cut exerting only gentle
pressure on the downward stroke, letting the saw
do the work.
2. MITER CUTS (SEE E)
A miter cut is made at 0
angle in the range from 45
Release the rotary
table locking knob
(13). Move the
saw to the desired
angle by twisting
so that the table
turns. Set at the
desired angle, and
tighten the rotary
table locking knob. Make your cut.
3. BEVEL CUTS (SEE F1, F2)
A bevel cut is made at 0°miter and any bevel
angle in the range
from 0° to 45°
left. The saw can
be moved from
the normal 0°
perpendicular
position to an
angled position
down to 45° from the horizontal, on the left only.
(See F1)
To adjust head tilt, release bevel lock knob and
tilt the saw head
to the left, until
the desired angle
is reached on the
angle scale. Re-
tighten the bevel
lock knob and
bevel and any miter
o
left to 45 right.
o o
make your cut. (See F2)
4. COMPOUND ANGLE CUTS (SEE G)
By using both
the rotary table
adjustment and the
head tilt, cutting of
compound angles
is possible. Fig.G
shows the saw
with 45 set on the
o
rotary table and the saw head tilted 45
5. LASER GUIDE (SEE H)
The laser guide (25) equipped with this machine
is for the purpose of precision cutting. Make sure
the batteries are fitted in the laser guide before
carrying out precision cutting. To fit the batteries,
remove the battery storage cover, insert 2 x 1.5v
AAA batteries, then
replace cover.
NOTE: Ensure
correct battery
polarity.
To use the laser
guide, simply slide
the laser on/off
switch at the "I"
position, the laser guide then projects a visible
red line on the workpiece surface, make your cut
along the red line.
Switch off the laser after cutting.
NOTE: The sawdust may "block" the laser beam,
clean the laser generator periodically.
WARNING: Never stare directly into
the laser beam and never point the
beam at anybody.
DANGER: Laser radiation. Avoid direct
eye contact with light source.
MAINTENANCE
WARNING: Remove the plug from
the socket before carrying out any
adjustment, servicing or maintenance.
When all the adjustments, settings or
maintenance have been done, make sure that
all keys and wrenches have been removed
and that all screws, bolts and other fittings
are securely tightened.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
.
o
37