Tabla de contenido
Idiomas disponibles
Idiomas disponibles
14. Use correctly sharpened saw blades, Observe the maximum speed marked on the saw blade.
15. Ensure that any spacers and spindle rings used suitable for the purpose as stated by the
manufacturer.
16. Retrain from removing any cut-off or other parts of the workpiece from the cutting area whilst the
machine is running and the saw head is not in the rest position.
17. Ensure that the machine is always fixed to a bench, whenever possible.
ADDITIONAL SAFETY RULES FOR YOUR MITER SAW
Remove the plug from the socket before carrying out any adjustment, servicing or
maintenance.
1. Only wood or products such as medium density fibre board can be cut with this saw. Other
materials may shatter or cause the blade to grab.
2. Never fit substandard blades. Only fit correctly size saw blades.
3. Let the blade reach full speed before commencing the cut.
4. Do not use damaged or worn blades.
5. Ensure that the direction arrow marked on the blade corresponds with the rotational direction of
motor.
6. Ensure the movable guard operate freely with out any jamming.
7. Never cut pieces too small to be held securely against the straight guide leave enough space for
the hand to be a safe distance from the blade.
8. Regularly check the blade-securing bolt.
9. Do not run the machine with any part of the casing missing or damaged.
10.Do not start the saw when the blade is inserted into the workpiece.
11. Before cutting let the saw blade run freely for a few seconds. If it makes an unfamiliar sound or
vibration switch it off immediately and disconnect from the power supply.
12.Never try to cut freehand. Always ensure that the workpiece is securely pressed against the straight
guide and blade support surface.
13.Do not forget to remove any adjustment keys, spanner and wrenches before switching on the tool.
14.When the machine is operating, keep hands away from the cutting area.
15.Always ensure the safety guard is in working order before use. Should the guard not close quickly
over the saw blade, do not use.
16.Do not tie or wedge open the safety guard.
17.Only use blades with the correct bore size for the spindle.
18.Do not cut into screw or nails. Inspect workpiece for nails and screws before use.
19.Keep the power cord well away from the cutting area during use. Always position the cord so that it
will not be caught in the workpiece when the saw is in use.
20.Do not use the saw to cut other than aluminium, wood or similar materials.
21.Take care when slotting.
SAFETY POINTS FOR YOUR LASER
The laser device fitted to this tool is CLASS 2 with a maximum radiation of 1 mW and 650 nm
wavelength. These lasers do not normally present an optical hazard although staring at the beam may
cause flash blindness.
Do not stare directly at the laser beam. A hazard may exist if you deliberately stare into the beam,
please observe all safety rules as follows:
1. The laser shall be used and maintained in accordance with the manufacturer's instructions.
2. Never aim the beam at any person or an object other than the work piece.
3. The laser beam shall not be deliberately aimed at another person and shall be prevented from
being directed towards the eye of a person for longer than 0.25 seconds area.
4. Always ensure the laser beam is aimed at a sturdy work piece without reflective surfaces, e.g.
34
Tabla de contenido
