Work Pro Digiline Serie Manual De Usuario página 27

4. The updating process starts. It will take some minutes. When it finish, a windows will be showed indicating
the device is updating successfully.
5. If you push the "i" symbol again, check the last line with the installed version and the word "updated"
together.
"^"
Also, the symbol
in the device line
6. Now the Digiline device is updated and ready to use the new WorkCAD software.
If you have used and setup a Digiline with a previous software version, take into account these points before
updating the device:
A. The GPIs previously stored in the DIGILINE device WILL BE DELETED AFTER UPDATING PROCESS and
must be to created again.
B. Check your current firmware version, if this version is 9.13.14.0.0 or later, the presets previously
stored in the DIGILINE ARE FULLY COMPATIBLE WITH THIS VERSION, Therefore, these presets DO NOT
BE DELETED AFTER UPDATING PROCESS
has dissapeared.
IMPORTANT
MX
MKII
The device has
being updated
PAGE 26