Work Pro Digiline Serie Manual De Usuario página 25

Limiter/Compressor
Since this command can set the filter and compressor in the required channel.
Again, remember to be aware of the values that are entered in the various parameters.
These values can affect not only the performance of the facility, but to the connected devices.
3. Presets: ....
With these commands you can set the preset parameters, either to rename, save,execute or set a backup point.
(See Section 3.2. PRESETS for additional information)
The commands are:
- SetName: To rename the selected preset.
- Set Editing State: Change Live mode / Edit on the device.
- Execute: Executes the selected preset
- Live Copy to Preset: Copy the preset in Live mode to a selected preset
- Live Push: Stores the preset as a backup to restore it after
- Live Pop: Restores the previously saved preset with Push, discarding any changes made meanwhile.
IMPORTANT: In the list of commands in this section shows a number of them starting with Preset: Get ....
and that they have associated parameters. In this case the scope of use is more focused to Ethernet
controlled by commands being sent back by the UDP port the requested information.
4. Channels: ....
With these commands you can rename both the inputs and outputs:
- Set Input Name: Change the name of the selected input
- Set Output Name: Change the name of the selected output
IMPORTANT: As in the previous section, the commands which incorporate "GET" behave similarly
5. UDP Port:
This command changes the UDP port value. Originally the value of this port is 9000
IMPORTANT
MX
MKII
PAGE 24