Connection Status - Work Pro Digiline Serie Manual De Usuario

3. DIGILINE INTERFACE
Once explained the common functions in all WorkCAD compatible devices. We pass to explain the specific DIGILINE
interface.
Once selected a device (from the Library or the Network) and checked that the device appears in PROJECT
INSPECTOR tab, it is time to open the configuration interface.
6
5
1. CONNECTION STATUS: This tab shows the status of the selected device:
The unit has been selected from
network (We are working over a
physical device).
In that case, the device IP address
is showed in the second line
2. PRESETS: DIGILINE devices allows to create and manage up to 9 presets to store different configurations. Using
this tab, you can select, Change their names, copy/paste and store them. Also, you can establish a backup point
and access to it (Push/Pop). Finally, you can work in LIVE or EDIT mode.
1
The device was in the previous state
but it has lost connection. Probably
it is turned off or LAN problem.
2
The device has been selected from
Library and it has not associated to
any physical device.
NOTE: See the (3.2. PRESET) section
for further information
MX
MKII
3
4
PAGE 10