Tabla de contenido
Idiomas disponibles
Idiomas disponibles
From here the process is identical, in the list of commands (Commands List) select the wished command
to edit.
The values introduction allows certain rules:
a. Parameter Range type that incorporate the following text:
Range (number, [first-last], [firs-last,another])
In this case the value can be numerical referred to a single channel:
1 for channel 1.
We can set a range of channels in brackets ([ ]) and separated with a hyphen (-):
[1-4], in this case we have selected the first 4 channels.
We may also collect both previous methods separating with commas (,):
[1-4], 6. In this case we have selected the channels 1-4 and 6.
We can also select alternate channels:
[1,3,6] allows us to select channels 1, 3 and 6 only.
As a last resort selection, we can make the following value:
*
. In this way you select ALL CHANNELS.
The use of these symbols allows us to reduce the number of commands.
b. Float type parameters that include the following text:
Float (float number) and in description (1 or 0)
Here are parameters of two states: 0 if not want to activate this parameter or 1 to activate
In this example we used the command Output Gain: Mute with Fade, you can select an output and
take it out of the state or a certain level Mute fade.
We applied that command on channels 1 to 4 and 6 [1-4,6] and activated the Mute status (1) in
the second line parameters.
c. Float type parameters that include the following text:
Float (float number) and in description (in dBs)
In this case these parameters allow edit the value in dBs.
d.
Float type parameters that include the following text:
Float (float number) and in description (negative for decrecement)
In this case these parameters allow edit the value in dBs.
value), this value reduces the value previously established in the amount of dBs marked, and a positive value
(no hyphen in front) increases it.
In this example we used the command Output Gain: Increment, which lets you select an output and
increase or decrease the gain value using the second line.
We applied that command on channel 2 by typing 2 in the first parameter and writing -5 in the second, of
This way, we will reduce the value 5dB previously had output number 2.
If the value is negative (placing a dash (-) before the
MX
MKII
PAGE 21
Tabla de contenido
