Craftsman CMXGRAM1130049 Manual De Instrucciones página 9

Note: This Operator's Manual covers several models. Tractor features may vary by
model. Not all features in this manual are applicable to all tractor models and the
tractor depicted may differ from yours.
Note: All references in this manual to the left or right side and front or back of the
tractor are from the operating position only. Exceptions, if any, will be specified.
Note: Some components may come already assembled. If they are already
assembled, skip ahead to the next step.
Contents of Crate
• Tractor
• Steering Pedestal Cap
• Discharge Chute Assembly
• Hardware Pack
• Product Registration Card
• Operator's Manual
• Rear Hitch Plate
• Mulch Plug
• Battery Charger
• Steering wheel/ Shaft Assembly
• Seat Assembly
• Seat Assembly
• Front Bumper
• Battery Charger Manual
Contents of Hardware Pack
Before beginning installation, remove all the contents from the crate and all the
hardware from the pack to make sure everything is present. Hardware is listed
below.
• Hitch Plate
• Seat Mounting Bracket (w/ two shoulder bolts & lock nuts installed)
Recommended Tools for Assembly
• 3/8" wrench and/or socket
• 7/16" wrench and/or socket
• 1/2" wrench and/or socket
• 9/16" wrench and/or socket
• Phillips screw driver
• 1/4" or 3/8"drive ratchet
Manually Moving the Tractor
The tractor can be moved as long as the parking brake is not set. Do not tow the
tractor. The tractor can be pushed slowly.
ASSEMBLY
Installing the Steering Wheel Assembly
If the steering wheel assembly for your tractor did not come already installed,
follow the steps below:
1. Slide the pedestal cap (a) onto the steering shaft (b) so that when the
steering shaft (b) is installed on the tractor, the pedestal cap (a) will be
upright as shown in Figure 1.
(b)
(a)
2. Remove the shoulder bolt (c) and lock nut (d) from the steering shaft and
retain for later steps. See Figure 2.
(a)
9
(a)
Figure 1
(c)
(c)
(b)
Figure 2
(b)
(d)
(d)