Battery Disposal - Craftsman CMXGRAM1130049 Manual De Instrucciones

Battery powered lithium-ion tractormontable alimentado por batería de ión de litio
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

4.
Remove blade (c) and adapter (d) from the deck motor spindle See Figure 24.
5.
To properly sharpen the cutting blade, remove equal amounts of metal
from both ends of the blade along the cutting edges, parallel to the trailing
edge, at a 25°- to 30° angle. Always grind each cutting blade edge equally to
maintain proper blade balance. See Figure 25.
6.
Test the blade's balance using a blade balancer. Grind metal from the heavy
side until it balances evenly.
A poorly balanced blade will cause excessive vibration, may damage
the tractor and/or result in personal injury.
Note: When replacing the blade, be sure to install the blade with the side of
the blade marked ''Bottom'' (or with a part number stamped in it) facing the
ground when the tractor is in the operating position.
Use a torque wrench to tighten the hex bolt to between 450-600 in-lbs.

Battery Disposal

Disposing of Damaged or Worn-Out Batteries
The following toxic and corrosive material is used in this battery:
LITHIUM-ION, a toxic material.
To prevent contamination of the environment, contact your local
waste disposal agency for specific instructions before disposing of
damaged or worn-out lithium-ion batteries. Take batteries to a local
recycling and/or disposal center, certified for lithium-ion battery
disposal.
SERVICE AND MAINTENANCE
Figure 25
WARNING
CAUTION
WARNING
WARNING
Do not use broken or cracked batteries, even if there is no leakage.
Replace damaged or worn-out batteries with new batteries. DO NOT
ATTEMPT TO REPAIR BATTERIES! Repair attempts may result in severe
personal injury, due to explosion or electrical shock.
To avoid personal injury and damage to the environment:
Do not attempt to remove or destroy any of the battery components. Do not
open or mutilate the battery. If a leak develops, released electrolytes are
corrosive and toxic. Do not get the solution in your eyes or on your skin, and
do not swallow it.
Do not dispose of the battery in the regular household trash.
Do not dispose of the battery in a fire. The cell may explode.
Do not dispose of the battery where it will become part of any waste landfill
or municipal solid waste stream.
Cover the battery terminals with heavy-duty adhesive tape.
Dispose of the battery according to local, state and federal regulations.
Dispose of the battery promptly.
About Call2Recycle® Battery Seals
Call2Recycle®'s industry steward program helps battery and
product manufacturers fulfill recycling requirements in the
U.S. and Canada, including compliance with extensive state,
provincial and federal regulations, such as the Mercury-
Containing and Rechargeable Battery Act (The Battery Act).
Call2Recycle® Licensees/Industry Stewards, participating battery and product
manufacturers and marketers, purchase the rights to imprint the Call2Recycle®
Battery Seals on their rechargeable batteries and products. When you see the
Call2Recycle® Battery Seal, you can feel confident knowing that your battery or
product can be safely and responsibly recycled.
About Call2Recycle®
Since 1994, Call2Recycle® has diverted more than 75 million pounds of rechargeable
batteries from local landfills and established a network of 30,000 recycling drop-off
locations. More than 200 battery and/or product manufacturers, Call2Recycle®
Industry Stewards, have united to ensure that batteries are responsibly recycled
when they reach their end of life and fund the program that is operated by
Call2Recycle®, Inc., a 501(c)4 nonprofit public service organization.
To locate the nearest recycling center, please call 1-800-822-8837.
Troubleshooting
Excessive Vibration
1.
Blade loose or unbalanced
Tighten cutting blade and deck spindle
2.
Cutting blade damaged, unbalanced or bent.
Replace the blade
Uneven Cut
1.
Deck not properly leveled
Perform front-to-rear deck adjustment
2.
Cutting blade dull or damaged
Sharpen or replace cutting blade
3.
Uneven tire pressure
Check and correct tire pressure in all four tires
Tractor will not mulch grass
1.
Wet grass
a.
Do not mulch when grass is wet
22
WARNING
Tabla de contenido
loading

Tabla de contenido