How To Use The Toll As Torch; Caution - Weller Pyropen Jr WSTA2 Manual De Uso

English
3. HOW TO USE THE TOOL AS TORCH
SWITCH RING
1. Loosen knurled cap to remove tip and tip housing.
2. Push up switch ring marked (A) and turn to right. Gas will start to flow.
Set mark °between "ON"-1.
3. Ignite by using a match or lighter as shown in above illustraion.
4. Adjust amount of flame by switch ring (1-3).
5. To turn off, slide the switch ring to "OFF" position.

4. CAUTION

1. Check tools for damage before use.
2. If damage is found, the device must not be used and the tank must not
be refilled.
3. Repairs are only to be performed by authorised specialist personnel.
4. Do not fill gas or store near open flame, heater, furnace or combustible
materials. Do not store at places under direct sunshine or any places that will
exceed 40°C.
18