Intended Use; Charging The Battery Pack [1] - Festool TRC 3 Manual De Instrucciones

The charger TRC 3 is design for charging the bat-
tery packs listed.
Only for use with the following battery packs:
• BPS 12 C NiCd 1.3 Ah
• BPS 12 C NiMH 3.0 Ah
• BPS 15,6 S NiCd 2.4 Ah
• BPS 15,6 S NiMH 3.0 Ah
• BPS Li 12 2.6 Ah
• BPS Li 15 2.6 Ah
• BPC 12 Li
• BPC 15 Li
The battery pack is delivered partially charged.
Charge the battery pack completely before us-
ing for the first time.
1-1
To charge the battery pack, slide all the way
onto the retainer [1-1] on the charger.
To remove, slide off the charged battery pack in
similar fashion.
All Festool battery packs of the series BPS and BPC
can be loaded with the charger. The charger auto-
matically detects the type of the inserted battery
(NiCd, NiMH or Li Ion). A microprocessor controls
the charging process in line with the charging state,
temperature and voltage of the battery pack. If a
warm NiMH battery pack (> 37 °C) is inserted, the
pack is charged with a reduced charging current
and will take longer to charge.
4

Intended use

The user will be liable for damage due to improp-
er use.

Charging the battery pack [1]

The LED [1-2] on the charger indicates the respec-
tive operating status of the charger.
LED yellow - lit continuously
Charger is ready to use.
LED green - flashing quickly
Battery pack is charged to maximum capacity.
LED green - flashing slowly
Battery pack is charged with reduced current, LiIon
is charged to 80 %.
LED green - lit continuously
Battery pack is fully charged, or charging is not
started again, because the battery is charged to
more than 80 %.
LED red - flashing
General fault display, e.g. incomplete contact, short
circuit, battery pack faulty, etc.
LED red - lit continuously
Battery temperature is outside the permitted
range.
WARNING
1-2