Nilfisk RS 1300 Instrucciones De Uso página 71

Problem
DRIVE POWER
The machine drive power is reduced
The machine has no drive power
DRIVE PEDAL
The machine moves even if the drive pedal is
released
CAB HEATING
There is no hot air
CAB CLIMATE CONTROL SYSTEM
There is no fresh air
DIESEL ENGINE
When turning the ignition key, the engine does
not start
NOTE
For diesel engine complete troubleshooting, see the relevant Manual.
INSTRUCTIONS FOR USE
Possible cause
The drive pedal is faulty
The by-pass is open
The drive system pump power decreases
Worn drive motors
Activated drive system pump deactivation
screw (to facilitate machine towing)
There are oil leaks from the hydraulic system
Broken drive system pump
Broken drive system motor
Misadjusted drive pedal
Broken hot water tap or pipes
There are water leaks from the heater
The switch is deactivated
The fuse is blown
The compressor does not turn because the
drive belt is loosen/broken
Deactivated thermostat
There are gas leaks from the system
The expansion valve is faulty
The switch is deactivated
The fuse is blown
There is an open in the gas pressure switch
The relay is burnt
The drive pedal is pressed.
RS 1300
Replace
Check the by-pass screw tightening
Check the hydraulic system oil pressure on the
drive system pump
Replace
Deactivate
Repair
Replace
Replace
Adjust
Replace
Replace
Activate
Replace
Adjust the tension/replace the belt
Activate
Repair the leak and integrate the gas
Replace
Activate
Replace
Replace
Replace
Do not press the drive pedal when starting the
engine.
33015124(3)2008-02
ENGLISH
Remedy
49