DeWalt DCF899 Manual De Instrucciones página 8

• Do not operate the charger if it has received a sharp blow,
been dropped or otherwise damaged in any way. Take it to
an authorized service cente_
• Do not disassemble the charger; take it to an authorized
service center when service or repair is required. Incorrect
reassemb/y may result in a risk of electric shock, electrocution or fire.
Disconnect the charger from the outlet before attempting
any cleaning. This will reduce the risk of electric shock.
Removing the battery pack will not reduce this risk.
NEVER attempt to connect two chargers togethe_
The charger is designed to operate on standard 120 volt
household electrical power. Do not attempt to use it on any
other voltage. This does not apply to the vehicular charge_
Chargers
Your tool uses a DEiWALT charger. Be sure to read all safety
instructions before using your charger. Consult the chart at the end of
this manual for compatibility of chargers and battery packs.
Charging Procedure (Fig. 1)
1. Plug the charger into an FIG.1
appropriate outlet before inserting
the battery pack.
2. Insert the battery pack (F)into the
charger, as shown in Figure 1,
making sure the pack is fully seated
in charger. The red (charging) light
will blink continuously, indicating
that the charging process has
started.
3. The completion of charge will be
indicated by the red light remaining
ON continuously. The pack is fully
charged and may be used at this time or left in the charger.
Indicator Light Operation
DCBI01, DCBI02, DCBI03
PACK CHARGING
PACK CHARGED
==HOT/COLODELAY me mO --O --e _O
_'_ PROBLEM PACK ORCHARGER• • • • • • • • • •
DCB 107, DCB 112, DCB 113, DCB 115
p.c.
Charge indicators
This charger is designed to detect certain problems that can arise.
Problems are indicated by the red light flashing at a fast rate. If this
occurs, re-insert the battery pack into the charger. If the problem
persists, try a different battery pack to determine if the charger is
working properly. If the new pack charges correctly, then the original
pack is defective and should be returned to a service center or other
collection site for recycling. If the new battery pack elicits the same
trouble indication as the original, have the charger and the battery
pack tested at an authorized service center.