Skil 9002 Manual De Instrucciones página 28

NOISE/VIBRATION INFORMATION
Measured values determined according to EN 60 745.
Typically the A-weighted noise levels of the tool
are: Sound pressure level: 90 dB (A). Sound power
level: 101 dB (A), uncertainty K=3d (B).
Wear ear protection!
The typical weighted acceleration is 5,5 m/s
certainty k=1,5 m/s .
2
* when surface grinding 8,1 m/s
* when sanding 6,2 m/s .
2
!
other application (such as cutting-off or
wire brushing) may have different vibration va-
lues.
The vibration emission level stated at the back of
this instruction manual (indicated by an asterisk)
has been measured in accordance with a stan-
dardised test given in EN 60745; it may be used to
compare one tool with another and as a prelimi-
nary assessment of exposure to vibration when
using the tool for the applications mentioned.
Using the tool for different applications, or with
different or poorly maintainted accessories, may
significantly increase the exposure level.
The times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
!
Protect yourself against the effects of vi-
bration by maintaining the tool and its acces-
sories, keeping your hands warm, and organiz-
ing your work patterns.
INFORMATION RECORDING STATIC
Slots in structural walls are subject to DIN 1053 part
1 or to provisions specific to a particular country.
These provisions must always be complied with.
Before starting work, consult the structural engi-
neer or architect responsible, or the relevant su-
pervision of works.
MOUNTING
!
Before any work on the machine itself,
pull the mains plug.
GRINDING/CUTTING DISCS (Figure 2)
!
Use only grinds tools whose allowable
speed is at least as high as the no-load speed
of the machine. Skil will not liable for problems
arising from inadequate use or from the assembly
of accessories / devices or similar out of specifi-
cation, developed by third parties in order to at-
tend the client's specifics needs.
!
Never use a grinding/cutting disc without
the label ("blotter") which is glued onto it.
!
Grinding/cutting discs become very hot
during use; do not touch them until they have
, un-
2
cooled down.
Clean spindle F and all parts to be mounted.
.
2
- Push spindle-lock button E.
- Tighten clamping flange J with key K.
!
When spindle F is locked, switch A can-
not be activated .
!
Actuate the spindle lock button only when
the grinder spindle is at a stand-still. Otherwise,
the machine may become damaged.
For removing accessories handle vice-versa.
!
Always mount backing pad when using
sanding accessories.
AUXILIARY HANDLE (Figure 3)
• Use auxiliary handles supplied with the tool.
Loss of control can cause personal injury.
For safety reasons, is mandatory the use of the
side handle C supplied with this product, and
which insures.
• a more stable haft
• an easer handing
PROTECTION GUARD WITH CLAMPING SCREW
(Figure 4)
Open protective guard D by loosening screw L.
Place protective guard D on the spindle collar of
the tool head and turn it to the required position
(depending on the work to be carried out).
Fasten protective guard D by tightening screw L.
!
Ensure that the closed side of the protec-
tive guard always points to the operator.
Adjust the protection guard D in such a man-
ner the sparking is prevented in the direction
of the operator.
Note: The encoding keys on the protection guard
D ensure that only a protection guard that fits the
machine type can be mounted.
OPERATING
BEFORE USING THE TOOL
• Observe correct mains voltage! The voltage
of the power source must agree with the vol-
28