During Use; After Use; Technical Specifications - Skil 9002 Manual De Instrucciones

• Do not clamp the tool in a vice.
• Use completely unrolled and safe extension
cords with a capacity of 16 Amps (U.K. 13 Amps).

DURING USE

• Inrush currents cause short-time voltage drops;
under unfavourable power supply conditions, oth-
er equipment may be affected (if the system im-
pedance of the power supply is lower than 0,104
+ j0,065 Ohm, disturbances are unlikely to occur);
if you need further clarification, you may contact
your local power supply authority.
• If the cord is damaged or cut through while work-
ing, do not touch the cord, but immediately disconnect
the plug; never use the tool with a damaged cord.
• In case of electrical or mechanical malfunction, im-
mediately switch off the tool and disconnect the plug.
• In case of current interruption or when the plug
is accidentally pulled out, unlock the on/off switch
J immediately in order to prevent uncontrolled re-
starting.

AFTER USE

• After switching off the tool, never stop the ro-
tation of the accessory by a lateral force applied
against it WHEN CONNECTING NEW 3-PIN PLUG
(U.K. ONLY):
• Do not connect the blue (= neutral) or brown (=
live) wire in the cord of this tool to the earth termi-
nal of the plug.
• If for any reason the old plug is cut off the cord
of this tool, it must be disposed of safely and not
left unattended.

TECHNICAL SPECIFICATIONS 1

Angle Gringer
Article Number
Power 127 - 220V
Frequency
Amperege
No-load speed
Capacity disc Ø
Grinding/cutting
Spindle thread
Weight according to EPTA 01/2003
Protection Class
* For Central América countries spindle thread 5/8".
DESCRIPTAL FUNCTION
INTRODUCTION
This tool is intended for grinding, cutting and de-
burring metal and stone materials without the use
of water; with the appropriate accessories the tool
can also be used for brushing and sanding.
The machine can be used only for dry cutting.
!
cut-off wheels are only allowed when a cut-off
guard is used. (Figure 9)
Read and save this instruction manual.
TOOL ELEMENTS 2 (Figure 1)
A On/off locking switch
B Ventilation slots
C Auxiliary handle*
D Protective guard
E Spindle-lock button
F Spindle
G Mounting flange*
H Grinding disc*
I Cutting disc*
J Clamping flange*
K Accessory key*
L Protective guard screw
M Allen key*
* The accessories shown or described are not part of
the product. Check the available accessories in the
sales program from your country.
[W]
[Hz]
127V [A]
220V [A]
[/min]
[mm]
[kg]
27
Cutting operations with bonded abrasive
9002 9004
F 012 900 2.. F 012 900 4..
600 700
50 / 60 50 / 60
5.0 5.8
2.9 3.4
10.000 11.000
115(4 1/2") 115(4 1/2")
M 14 x 2 M 14 x 2
2,4 2,4
/ II / II