Preventive Measures - Palmer PDI09 The Junction DI box Manual De Usuario

Tabla de contenido

PREVENTIVE MEASURES

EN
1.Please read these instructions carefully.
2.Keep all information and instructions in a safe place.
3.Follow the instructions.
4.Observe all safety warnings. Never remove safety warnings or other information from the
equipment.
5.Use the equipment only in the intended manner and for the intended purpose.
6.Use only sufficiently stable and compatible stands and/or mounts (for fixed installations). Make
certain that wall mounts are properly installed and secured. Make certain that the equipment is
installed securely and cannot fall down.
7.During installation, observ
e the applicable safety regulations for your country.
8.Never install and operate the equipment near radiators, heat registers, ovens or other sources
of heat. Make certain that the equipment is always installed so that is cooled sufficiently and
cannot overheat.
9.Never place sources of ignition, e.g., burning candles, on the equipment.
10.Ventilation slits must not be blocked.
11.Do not use this equipment in the immediate vicinity of water (does not apply to special
outdoor equipment - in this case, observe the special instructions noted below. Do not expose
this equipment to flammable materials, fluids or gases. Avoid direct sunlight!
12.Make certain that dripping or splashed water cannot enter the equipment. Do not place con-
tainers filled with liquids, such as vases or drinking vessels, on the equipment.
13.Make certain that objects cannot fall into the device.
14.Use this equipment only with the accessories recommended and intended by the manufacturer.
15.Do not open or modify this equipment.
16.After connecting the equipment, check all cables in order to prevent damage or accidents,
e.g., due to tripping hazards.
17.During transport, make certain that the equipment cannot fall down and possibly cause pro-
perty damage and personal injuries.
18.If your equipment is no longer functioning properly, if fluids or objects have gotten inside
the equipment or if it has been damaged in anot her way, switch it off immediately and unplug
it from the mains outlet (if it is a powered device). This equipment may only be repaired by
authorized, qualified personnel.
19.Clean the equipment using a dry cloth.
20.Comply with all applicable disposal laws in your country. During disposal of packaging,
please separate plastic and paper/cardboard.
21.Plastic bags must be kept out of reach of children.
FOR EQUIPMENT THAT CONNECTS TO THE POWER MAINS
22.CAUTION: If the power cord of the device is equipped with an earthing contact, then it
must be connected to an outlet with a protective ground. Never deactivate the protective
ground of a power cord.
23.If the equipment has been exposed to strong fluctuations in temperature (for example, af-
ter transport), do not switch it on immediately. Moisture and condensation could damage the
equipment. Do not switch on the equipment until it has reached room temperature.
24.Before connecting the equipment to the power outlet, first verify that the mains volta-
ge and frequency match the values specified on the equipment. If the equipment has a voltage
selection switch, connect the equipment to the power outlet only if the equipment values and
the mains power values match. If the included power cord or power adapter does not fit in your
wall outlet, contact your electrician.
25.Do not step on the power cord. Make certain that the power cable does not become kinked,
especially at the mains outlet and/or power adapter and the equipment connector.
26.When connecting the equipment, make certain that the power cord or power adapter is always
freely accessible. Always disconnect the equipment from the power supply if the equipment
is not in use or if you want to clean the equipment. Always unplug the power cord and power
adapter from the power outlet at the plug or adapter and not by pulling on the cord. Never
touch the power cord and power adapter with wet hands.
27.Whenever possible, avoid switching the equipment on and off in quick succession because
otherwise this can shorten the useful life of the equipment.
28.IMPORTANT INFORMATION: Replace fuses only with fuses of the same type and rating. If a
fuse blows repeatedly, please contact an authorised service centre.
29.To disconnect the equipment from the power mains completely, unplug the power cord or pow-
er adapter from the power outlet.
30.If your device is equipped with a Volex power connector, the mating Volex equipment con-
nector must be unlocked before it can be removed. However, this also means that the equipment
can slide and fall down if the power cable is pulled, which can lead to personal injuries
and/or other damage. For this reason, always be careful when laying cables.
31.Unplug the power cord and power adapter from the power outlet if there is a risk of a
lightning strike or before extended periods of disuse.
2
Tabla de contenido
loading

Tabla de contenido