Mechanical Installation - Blue I HydroGuard HG-302 Manual De Uso

3.2.2 Mechanical Installation

The following procedure instructs how to install the HydroGuard unit in a pool pump room.
1. HydroGuard is shipped pre-mounted on a mounting panel, along with a water filter. The mounting
panel includes four screw holes, one in each corner.
2. Determine the location of one hole on the HydroGuard unit or on the mounting panel.
3. Mark the location of the screw hole and drill a hole for a screw anchor.
4. Screw one corner of the HydroGuard unit or mounting panel to the wall.
5. Level the HydroGuard unit or mounting panel and mark the remaining three (3) screw holes.
6. Drill the three (3) remaining holes, insert anchors, and screw the remaining corners to the
wall using 5/16" (8 mm) screws.
Step 3:
Mark first hole, drill and screw
mounting panel to wall.
Mounting
Panel
HydroGuard
Controller
Mounting panel
Step 5:
Level HydroGuard unit and
mark the remaining 3 holes.
Figure 2: Mounting HydroGuard on the Wall
Filter
Figure 3: HydroGuard unit Mounting Panel
11
Step 6:
Drill the 3 holes and screw
mounting board to wall.
Use 5/16" (8 mm) screws.
4 Mounting holes
HydroGuard unit