Configuring Settings In The Operator Menu; Enter Password - Blue I HydroGuard HG-302 Manual De Uso

4.3.3 Configuring Settings in the Operator Menu

Each of the parameters in the operator menu is configured in the same way. The following procedure
describes how to configure a typical setting:
1. Locate the desired parameter in the menu:
Press (Scroll) until the desired parameter name appears in the LCD display.
Enter
Press (Enter).
Enter Password 100 appears in the LCD display.

ENTER PASSWORD

2. Enter the Operator password (the technician password will also be accepted)
Press the up arrow
Note: Holding Scroll why pressing up or down will advance the first digit. Holding up or down for an
extended period of time will proceed through the numbers more quickly.
The factory-set operator password is 123. The operator password can only be changed by
entering the current operator or technician password (see 4.5 Technician Menu Setup).
Enter
Press (Enter) to accept the password.
The parameter name and current setting appear in the LCD display.
Enter
Press (Enter). The LCD display shows the parameter and the current setting.
3. Enter the new parameter setting:
Press the up arrow
The second row of the LCD display, below the value that is being changed, shows the current
value, see Figure 15.
Enter
4. Press (Enter) to save the new setting or
new setting.
To change the settings of additional parameters, press
appears in the LCD display and repeat steps 3 and 4 above to set the new parameter.
or down arrow until the password number is reached.
or down arrow until the desired value is reached.
25
100
100
Esc
(Esc) to abort without saving the
(Scroll) until the desired parameter