New Menus And Settings; Operator Menu - Blue I HydroGuard HG-302 Manual De Uso

7. Locate the Pump and Up button on the HydroGuard HG-302 control panel.
8. Press the Pump and Up button together for ninety (90) seconds until the reagent drops visible through
the DPD 3 needle

6.2.3 New menus and settings

The total chlorine monitoring requires a few additional menus and alarms and requires a few additional
settings to be configured before operating the controller.

6.2.3.1 Operator Menu

The following table lists the parameters in HydroGuard's Operator menu:
Menu #
1
2
Cl Calibrated to
3
Cl Sensor was
4
5
6 Cl interval min
7 Cl interval max
8
pH Calibrated to
9
pH Sensor was
10
11
12 ORP Set Point1
ORP Calibrated to
13
ORP Sensor was
14 ORP low alarm
15 ORP High alarm
16 Temp Set Point
Temp Calibrated to
17
Temp Sensor was
18 Temp Low Alarm
19 Temp High Alarm
20 Turbidity set point
21 Turb. High alarm
Name
Cl Set Point1
Cl Set Point2
Cl low alarm
Cl high alarm
pH set point
pH low alarm
pH high alarm
Alarm when ORP above this value + Open Cl relays 1+2
Alarm when Turbidity above this value - optional module
Description
Controls Cl Relay 1 - On/Off or Proportional
Controls Cl Relay 2 - On/Off only
shows most recent calibration and sensor value at
calibration to aid in troubleshooting
Alarm when Cl below this value
Alarm when Cl above this value
Minimum time between Cl measurements
Maximum time between Cl measurements
Controls pH Relay 3 - On/Off or Proportional
shows most recent calibration and sensor value at
calibration to aid in troubleshooting
Alarm when pH below this value
Alarm when pH above this value
ORP set-point for emergency mode only
shows most recent calibration and sensor value at
calibration to aid in troubleshooting
Alarm when ORP below this value
Controls Temperature Relay 6
shows most recent calibration and sensor value at
calibration to aid in troubleshooting
Alarm when Temp below this value
Alarm when Temp above this value
Controls Turbidity Relay 4 - optional module
58