Ryobi TSS121 Manual Del Operador página 26

CUTTING WITH YOUR COMPOUND MITER SAW
WARNING:
When using a work clamp, C-clamp, or other suitable
clamp to secure your workpiece, clamp workpiece on one
side of the blade only. The workpiece must remain free on
one side of the blade to prevent the blade from binding
in workpiece. The workpiece binding the blade will cause
motor stalling and kickback. This situation could cause
an accident resulting in possible serious personal injury.
WARNING:
NEVER move the workpiece or make adjustment to any
cutting angle while the saw is running and the blade is
rotating. Any slip can result in contact with the blade
causing serious personal injury.
WARNING:
Do not try to cut narrow pieces using the sliding feature.
Failure to heed this warning could result in serious
personal injury.
LED LIGHTING SYSTEM
See Figure 30.
WARNING:
Do not stare into the light beam (not even from a distance).
Staring into the light beam may result in serious injury or
vision loss.
The LED lighting system casts the shadow of the blade onto
the workpiece. This results in greater accuracy of cuts and
requires no adjustments.
To use this feature, turn the LED switch on.
Bring the saw arm down so that the blade is approximately
1/4 in. from the workpiece. The shadow of the blade will be
projected onto the workpiece, indicating where the blade
teeth will make contact as the cut is made.
OPERATION
SHADOW OF BLADE
TEETH PROJECTED
ONTO WORKPIECE
26 − English
LED
SWITCH
Fig. 30