Shindaiwa HomePro T195s Manual Del Propietário página 7

Assembly and Adjustments
T195s Cutting Attachment Shield Installation
Socket-
Head Cap
Screw
Bracket
Shim
Clamp
Screw
Retaining
Nut
1025
Figure 8
Install the Cutting
Attachment Shield.
1. Insert the cutting attachment shield
between the outer tube and the cut-
ting attachment mounting plate. See
Figure 8.
NOTE:
It may be necessary to loosen the retaining
nut and clamp screw to adjust cutting attach-
ment shield mounting plate.
Assembly and Adjustments
Trimmer Head Installation
1. Position the trimmer with the
gearcase output shaft pointing up as
shown in the illustration.
2. Install the spacer onto the output
shaft.
3. Install the tool holder and align the
hole on the side of the holder with the
notch on the gearcase as shown in the
illustration.
4. Insert a 4 mm hex wrench through
the tool holder hole and the gearcase
notch to lock the tool holder to
the gearcase.
5. While holding the tool holder locked
with the 4 mm hex wrench, thread
the trimmer head onto the output
shaft.
6. Remove the hex wrench to unlock the
tool holder. Rotate the trimmer head
by hand to ensure that it does not
bind and rotates freely.
Outer
Tube
Line Cutter
Shim
Cutting
Attachment
Mounting
Hex
Plate
Screws
Figure 8A
2. Fit the two shims and the bracket
over the outer tube and loosely install
the four socket-head screws.
See Figure 8.
CAUTION!
Make sure the clamp screw and
retaining nut are securely tightened
before tightening the four socket
head cap screws.
Spacer
Figure 9
WARNING!
A standard grass trimmer with a loop
handle should NEVER be operated
with blade-type attachments.
T195s
NEVER operate the T195s with-
out the cutting attachment shield
installed and tightly secured!
Cutting Attach-
ment Shield
The line cutter can be positioned in
2 positions to obtain different line length
for cutting.
Nuts
The line cutter is very sharp. Wear
gloves to protect your hands when
handling.
To Change Position of Line Cutter.
1. Remove the 2 hex screws with a
4 mm hex wrench. See Figure 8A.
2. Rotate line cutter. See Figure 8A.
3. Reinstall the two hex screws and
tighten them securely.
Be careful to not lose the 2 nuts in the
cutting attachment shield, they are not
captured.
Tool Holder
Output
Shaft
Gearcase Notch
WARNING!
WARNING!
NOTE:
Install Trimmer Head
COUNTER-CLOCKWISE (T195s),
CLOCKWISE (F195s)
7