Tabla de contenido
Idiomas disponibles
Idiomas disponibles
÷
÷
Basic connections
I
Antenn. toDVDtVCR
connectio. I I
DVDtVCR
to7V co.._otio.
]
The DVD/VCR must be connected "between" the antenna and
the TV. First, disconnect the antenna from the TV and connect
it to the DVD/VCR.
Then connect the DVD/VCR
to the TV.
Below are 3 common methods of connecting an antenna sys-
tem to a DVD/VCR.
Find the type of antenna system you are
using and follow the connection diagram.
Example
1:
Combination
VNFiUNF antenna w{th 78 ohm
coaxial
cable
75 ohm coaxial
O'_
i........!cable
_t_oII
DVD/MCR
Example
2:
Combination VNF/UNF antenna with 300 ohm
twin lead (fiat) wire
300 ohm twin lead
[ ........ ylat) wire
Matching transformer
300 ohm input 75 ohm
output (not supplied)
DVD/VCR
Example 3:
Separate
VHF and UNF antennas
Combiner
75/300 ohm inputs
75 ohm output (not supplied)
VHF
UHF
I
, lead/flat/w r%_. II
........ _'"';_
_._%j
_;o II
75 ohm coaxial
cable
DVD/VCR
NOTE:
tf both VHF and UHF antennas have 300 ohm twin lead (flat)
wires, use a combiner having two 300 ohm inputs and one 75
ohm output.
NOTES:
A clear picture will not be obtained by the main unit unless
the antenna signal is good. Connect the antenna to the
main unit properly.
For better quatity
recording,
an indoor
antenna
or a
telescopic antenna
is not recommended.
The use of an
outdoor type antenna is required.
If you are not sure about the connection, ptease refer to
qualified service personnel.
After you have connected the antenna to the DVD/VCR,
you
must connect the DVDNCR
to the TV.
Below are 3 common methods of connecting your DVD/VCR
to a TV. Find the type of TV you are using and follow the con-
nection diagram.
This DVD/VCR has a single 75 ohm output for connection to a
TV. If your TV has separate VHF and UHF antenna inputs (num-
bers 2 and 3 below), use a splitter to connect the DVD/VCR to
the TV for VHF and UHF reception.
Example
1:
TV with single 78 ohm VHFIUNF antenna
input
75 ohm coaxial
TV
_I
cable (supplied)
DVD/VCR
Example
2:
TV with 300 ohm UNF and 75 ohm VHF
antenna
inputs
._
75 ohm coaxial cable
(supplied)
J,1@_,_,- _
J
<,,_,o
II
I
..,Z,'J/_ I
DVD/VCR
Splitter 75 ohm input
75/300 ohm outputs
(not supplied)
Example
3:
=IV with 300 ohm UNF and 300 ohm VNF
antenna
inputs
TV
75 ohm coaxial cable
(supplied)
177"
<,,';_:
o II
I
__/,/"_ _
DVD/VCN
Splitter 75 ohm input
300 ohm output
(not supplied)
NOTE:
If a VNF or UNF antenna is used, set the TV/CABLE
menu
option to the "TV" mode.
÷
10
2F3P421A[E](10-17)
÷
1/25/05. 12:01 PM
Capítulos
Tabla de contenido
