First Use; Personalisation; Acoustic Signals; Daily Use - Zanussi ZWT 71401 WA Manual De Instrucciones

The Selected delay set by pressing the relevant button
appears on the display for few seconds, then the dura-
tion of the selected programme is displayed again.
• Alarm codes
In the event of operating problems, some alarm codes
can be displayed, for example E20 (see paragraph
«What to do if...»).
• Incorrect option selection

First use

• Ensure that the electrical and water connections
comply with the installation instructions.
• Remove the polystyrene block and any material
from the drum.
• Pour 2 litres of water into the main wash com-
partment of the detergent drawer in order to

Personalisation

Acoustic signals

The machine is provided with an acoustic device, which
sounds in the following cases:
• at the end of the cycle
• if there is a fault.
By pressing the 4 and 5 buttons simultaneously for about
6 seconds, the acoustic signal is deactivated (except if
there is a fault). By pressing these 2 buttons again, the
acoustic signal is reactivated.
Child safety lock
This device permits you to leave the appliance unattended
and not to worry that children might be injured by or

Daily use

Washing only
Load the laundry
Open the door by carefully pulling the door handle out-
wards. Place the laundry in the drum, one item at a time,
shaking them out as much as possible. Close the door.
Make sure that no laundry stays between the seal and the
door. There is a risk of water leakage or damage to the
laundry.
www.zanussi.com
If an option which is not compatible with the set wash
programme is selected, the message Err is displayed at
the bottom of the display for a few seconds and the in-
tegrated red light of button 8 start flashing.
• End of programme
When the programme has finished three flashing zeros
are displayed, the pilot light 9 and the pilot light of but-
ton 8 go out and the door can be opened.
activate the ECO valve. Then run a cotton cycle at
the highest temperature without any laundry in
the machine, to remove any manufacturing resi-
due from the drum and tub. Pour 1/2 a measure
of detergent into the main wash compartment and
start the machine.
cause damage to the appliance. This function remains en-
abled also when the washing machine is not working.
There are two different ways to set this option:
1. Before pressing button 8: it will be impossible to
start the machine.
2. After pressing button 8: it will be impossible to
change any other programme or option.
To enable or disable this option press simultaneously for
about 6 seconds buttons 2 and 3 until on the display, the
icon appears or disappears.
Measure out the detergent and the fabric softener
Pull out the dispenser drawer until it stops. Measure out
the amount of detergent required, pour it into the main
wash compartment or in the appropriate compartment
7