Zanussi ZWT 71401 WA Manual De Instrucciones página 24

6. Fill the smaller upper hole and the two large ones
with the corresponding plastic plug caps supplied in
the bag containing the instruction booklet.
Positioning
Install the machine on a flat hard floor. Make sure that air
circulation around the machine is not impeded by carpets,
rugs etc. Check that the machine does not touch the wall
or other kitchen units. Level the washing machine by rais-
ing or lowering the feet. The feet may be tight to adjust as
they incorporate a self locking nut, but the machine MUST
be level and stable. If necessary, check the setting with a
spirit level. Any necessary adjustment can be made with a
spanner.
Accurate levelling prevents vibration, noise and displace-
ment of the machine during operation.
Caution! Never place cardboard, wood or similar
materials under the machine to compensate for any
unevenness in the floor. After having levelled the
appliance, tighten the lock nuts.
24
Water inlet
Warning! This appliance must be connected to a
cold water supply.
1. Connect the water inlet hose supplied with the ma-
chine to a tap with a 3/4" thread. Always use the
hose supplied with the appliance.
Important! Do not use the hose from your previous
machine to connect to the water supply.
2. The other end of the inlet hose which connects to the
machine can be turned as showed in the picture.
Do not place the inlet hose downwards.
Angle the hose to the left or right depending on the
position of your water tap.
35°
3. Set the hose correctly by loosening the ring nut. Af-
ter positioning the inlet hose, be sure to tighten the
ring nut again to prevent leaks.
The inlet hose must not be lengthened. If it is too short
and you do not wish to move the tap, you will have to pur-
chase a new, longer hose specially designed for this type
of use.
45°
www.zanussi.com