Helpful Hints And Tips - Zanussi ZWT 71401 WA Manual De Instrucciones

Ocultar thumbs Ver también para ZWT 71401 WA:
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

4.
If you wish to select a timed drying, press button 5
until the time you want appears on the display (see
the «Drying Programme» table). Every time you
press this button the drying time increases by 5 mi-
nutes.
Note!
The programme time will automatically increase by
some minutes.
5.
Press button 8 to start the programme.
After the programme has started, the time remaining
is updated every minute.
Note!
The different type of cottons (towelling, sheets,
shirts, and so on) or any laundry items rolling up
during the spinning phase may result in partial dry-
ness. In the exceptional case that at the end of the
cycle the laundry remains slightly wet, we suggest
that you unfold the rolled up items, redistribute them
evenly in the drum and select an additional drying
cycle of 20-30 minutes.
6.
At the end of the programme, the buzzer sounds and
three blinking «0.00» appear on the display and the
pilot light 9is on to indicate that the door is locked.
The last 10 minutes of the drying cycle correspond
to an anti-crease phase. During this time the door is
locked and the display keeps showing three flashing
zeros «0.00».
If you wish to open the door before or during the
anti-crease phase or to interrupt it, press any button
or turn the programme selector dial to any programme po-
sition (except O).
7.
Turn the selector dial to the O position to switch the
machine off.
8.
Remove the laundry.
Automatic washing and drying (NON-STOP
programme)
For NON-STOP programmes, the recommended load size
is 3 kg for cotton and 1,5 kg for synthetic.

Helpful hints and tips

Sorting out the laundry
Follow the wash code symbols on each garment label and
the manufacturer's washing instructions. Sort the laundry
as follows: whites, coloureds, synthetics, delicates, wool-
lens.
10
It is possible to dry up to 4 kg of cotton items by
pressing Drying Time button only (see the «Drying
Programme » table).
Caution! Do not use a dosing device/ball when
carrying out a washing and drying programme.
1.
Load the laundry.
2.
Add detergent and fabric softener.
3.
Switch the machine on by turning the selector dial to
the selected washing programme/fabric.
4.
Select the required options by pressing the relevant
buttons.
If possible, do not select a spin speed lower than that
proposed by the appliance to avoid too long a drying time
therefore saving energy.
In any case the reduction of the spin speed is only
possible after selecting drying.
The lowest values you can select are the following:
– 900 r.p.m. for cottons and synthetic with elec-
tronic drying;
– 900 r.p.m. for cottons and 700 r.p.m. for fabrics
with timed drying.
5.
Select the drying time by pressing button 5. The dis-
play shows the entire duration of the washing and
the selected drying cycle.
6.
Start the programme by pressing button 8. After the
programme has started, the time remaining is upda-
ted every minute.
7.
At the end of the programme turn the selector dial to
the O position to switch the machine off.
8.
Remove the laundry.
www.zanussi.com

Capítulos

Tabla de contenido
loading

Tabla de contenido