Hama EWS-810 Instrucciones De Uso página 8

• Press the + button (17) repeatedly to set the channel to that set on the respective
measuring station – see 4.1. Measuring station . CH1, CH2, CH3 (9) or Channel
overview (10) is displayed.
• The base station now shows the temperature measured (8) on the selected measuring
station (9).
• Select Channel overview (10) to show the measurement values of the individual measuring
stations/channels consecutively for 5 seconds each.
6.3. Basic and manual settings
Automatic setting using the DCF signal
• After the rst time the base station is switched on and successful transmission is established
between the base station and the measuring station, the clock will automatically search for
a DCF signal. During the search, the wireless symbol (13) will ash.
Display
Flashing
Displayed continuously
No display
• If the station still does not receive a signal, press and hold the – button (18) for approx. 3
seconds to start the manual search for the DCF signal. The wireless symbol (13) will start
to ash.
Note – Time settings
• The search process takes about 7 minutes. If the search fails, it ends and is repeated at
the next clock hour. The wireless symbol (13) will go out.
• In the meantime you can, however, set the time and the date manually.
• The clock automatically continues to search for the DCF signal on a daily basis (between
1:00 a.m. and 3:00 a.m.). If the signal is received successfully, the manually-set time
and date are overwritten.
Searching for the DCF signal
Active
Successful – signal is being received
Deactivated
7