Tabla de contenido
Page
-24-
HOW TO PREPARE THE MACHINE
FOR OPERATION
CAUTION:
Irreversible damage will occur to the batteries
if the electrolyte level does not cover the plates.
Keep the electrolyte at the correct level.
3.
Reinstall the caps.
4. After charging, top off the batteries. NOTE: USE DISTILLED WATER
ONLY. THIS SHOULD BE DONE AFTER CHARGING. The maximum
level is within 1/4 inch of the bottom of the tube in each cell. See
figure 5 B. For instructions on how to charge the batteries, see
"How To Charge The Batteries" below.
CAUTION:
Machine damage and discharge across the
tops of the batteries can occur if the batteries
are filled above the bottom of the tube in each
cell. Do not fill the batteries up to the bottom of
the tube in each cell. Wipe any acid from the
machine or the tops of the batteries. Never add
acid to a battery after installation.
CAUTION:
Tap water may contain contaminants that will
damage batteries. Batteries must be re-filled
with distilled water only.
5.
Keep the tops of the batteries clean and dry.
Keep the terminals and connectors clean. To clean the top of the
batteries, use a damp cloth with a weak solution of ammonia or
bicarbonate of soda solution. To clean the terminals and connec-
tors, use a terminal and connector cleaning tool. Do not allow
ammonia or bicarbonate of soda to get into batteries.
6.
Keep the batteries charged.
How To Charge The Batteries
WARNING:
Charging the batteries in an area without ad-
equate ventilation could result in an explosion.
To prevent an explosion, charge the batteries
only in an area with good ventilation.
WARNING:
Lead acid batteries generate gases which
could explode. Keep sparks and flames away
from batteries. NO SMOKING!
CAUTION:
See Charger Owner's Manual. All onboard
battery chargers are programmed for a spe-
cific type battery. The charger may need repro-
gramming to properly charge replacement
batteries different than the originally equipped
Clarke battery.
NOTE: Only replace batteries with the identical Clarke battery
pack as originally equipped. The correct Clarke battery part
number can be found on the Clarke battery label affixed to the
top of each battery.
If the replacement battery is a different Clarke battery, please
contact Clarke Technical Service, 1-800-356-7274, for
instructions.
If the replacement battery is not a Clarke battery, please contact
the charger manufacturer for instructions.
To charge the batteries, follow this procedure:
1.
Make sure the key switch is in the "OFF" position.
2.
Connect the charger to a properly grounded single phase (3-wire)
wall receptacle having the voltage,
capacity specified on the nameplate of the charger.
®
Clarke
Operator's Manual -Fusion 27 Battery Burnisher
EN
frequency, and ampere
Tabla de contenido
