Tabla de contenido
Idiomas disponibles
Idiomas disponibles
How to Use Accessory
Tray
The unit is equipped with an accessory tray with
places to store your spray gun, nozzle extension, high
pressure hose and selector nozzle.
1.
Place spray gun in wide groove on accessory tray
as shown. Pull rubber strap tight around spray gun
and place hole in strap over tab on accessory tray.
2.
Place nozzle extension in narrow groove on
accessory tray. Pull rubber strap tight around
nozzle extension and place hole in strap over tab
on accessory tray.
3.
insert selector nozzle in hole provided on front of
accessory tray.
4.
Place one end of high pressure hose in groove at
top of accessory tray and wrap high pressure hose
around hooks as shown.
How to Use SeJector
NozzJe
The selector nozzle allows you to switch between five
different spray pattern nozzles. Spray patterns can be
changed while pressure washer is running once spray
gun trigger safety lock is engaged. The spray patterns
vary as shown below.
WARNING
The high pressure stream of water
that this equipment produces could cut
through skin and its underlying tissues,
resulting in serious injury and possible
amputation.
o NEVER change spray patterns without the trigger locked
on the spray gun.
DO NOT twist selector nozzle while spraying.
Follow these instructions
to change
nozzle
patterns:
1.
Select desired spray pattern:
•
MAX - For stubborn or hard to reach surface
such as second story surfaces, paint removal,
oil stains, rust removal or other stubborn
substances (tar, gum, grease, wax, etc.).
GENERAL - For most all purpose cleaning
such as home siding, brick patios, wood decks,
driveways and sidewalks, garage floors, etc..
DEUOATE - For gentle cleaning of cars/trucks,
boats, RV's, patio furniture, lawn equipment,
etc..
FLUSH - For quick high flow clean up and
long reach cleaning of second story siding and
windows.
SOAP
For general soap applications or
to launch soap to second story siding and
windows.
2.
Push button on selector nozzle, nozzle dial will pop
up.
3.
Turn dial until desired spray pattern lines up with
button on selector nozzle.
4.
Push dial in until it locks into place.
Usage Tips
•
For most effective cleaning, keep selector nozzle
from 8 to 24 inches (20 to 61 cm) away from
cleaning surface.
•
If you get selector nozzle too close, especially using
a high pressure spray pattern nozzle, you may
damage surface being cleaned.
•
DO NOT get closer than 6 inches (15 cm) when
cleaning tires.
14
Tabla de contenido
