Tabla de contenido
Idiomas disponibles
Idiomas disponibles
HOW TO USE YOUR PRESSURE
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-222-3136.
Pressure
Washer
Location
Carbon
Monoxide
Poisoning
WARNING
POISONOUS
GAS HAZARD.
Engine exhaust
contains
carbon
monoxide,
a poisonous
gas that could kill you in
minutes.
You CANNOT
smell it, see it, or
taste it. Even if you do not smell exhaust
fumes, you could still be exposed
to carbon
monoxide
gas.
, Operate this product ONLY outside far away from
windows, doors and vents to reduce the risk of carbon
monoxide gas from accumulating and potentially being
drawn towards occupied spaces.
, Install battery-operated
carbon monoxide alarms or
plug-in carbon monoxide alarms with battery back-up
according to the manufacturer's instructions. Smoke
alarms cannot detect carbon monoxide gas.
, DO NOT run this product inside homes, garages,
basements, crawlspaces, sheds, or other partially-
enclosed spaces even if using fans or opening doors and
windows for ventilation. Carbon monoxide can quickly
build up in these spaces and can linger for hours, even
after this product has shut off.
, ALWAYS place this product downwind and point the
engine exhaust away from occupied spaces.
If you start to feel sick, dizzy, or weak while using this
9roduct, shut it off and get to fresh air RIGHT AWAY. See a
doctor. You may have carbon monoxide poisoning.
Exhaust
Port
Pointed
away from
occupied
spaces
Risk of Fire Clearances
_, WARNING
Exhaust heat/gases could ignite
combustibles, structures or damage fuel tank
causing a fire, resulting in death or serious injury.
o Keep at least 5 ft. (1.5 m) clearance on all sides of
pressure washer including overhead.
To Start Your Pressure
Washer
To start your engine-powered
pressure washer for the
first time, follow these instructions step-by-step. This
information also applies whenever you start the engine
after you have let the pressure washer sit idle for at
least a day.
1.
Place pressure washer outside near an water
source capable of supplying water at a flow rate
greater than 3.7 ga/ons per minute and no less than
20 PSI at pressure washer end of garden hose.
2.
Check that high pressure hose is tightly connected to
spray gun and pump. See Assemb(y for illustrations.
3.
Make sure unit is in a level position.
4.
Connect garden hose to water inlet on pressure
washer pump.
NOTICE
DO NOT run the pump without the water
supply connected and turned on.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
5.
Turn ON the water, press red button on the gun and
squeeze the trigger to purge the pump system of air
and impurities.
6.
Attach nozzle extension to spray gun. Tighten by hand.
7.
Pul back on collar of nozzle extension, insert
selector nozzle and release collar. Tug on selector
nozzle to make sure it is securely in place. See
How to Use Selector Nozzle.
8.
Push engine rocker switch (B) to on position (I or ON).
J
12
Tabla de contenido
