Environmental Protection; Cleaning, Disinfection And Maintenance Of The Ice And/Or Water Dispenser (Where Fitted); Installation - Bertazzoni REF75PIXL Manual Del Usuario

Symbols used in this manual:
N.B.
Suggestions for correct use of the
appliance
Important
Instructions for preventing damage to the
appliance
Warning
Instructions for preventing personal injury

1.3 Environmental Protection

> Pay particular attention to the correct method of
disposal for all packaging components.
> The appliance must not be disposed of with
general domestic refuse. Enquire at an authorised
local waste disposal/recycling
disposal of recyclable materials.
> When disposing of the appliance, cut the power
cable off and remove or modify the door so that it
cannot be closed.
>
Ensure that the refrigeration circuit does not
sustain damage during disposal.
> The appliance's refrigeration circuit and insulation
do not contain substances which can damage the
ozone layer.
1.4 Cleaning, Disinfection and
Maintenance of the Ice and/or Water
Dispenser (where equipped)
Failure to comply with the disinfection instructions
given can compromise the hygiene of the dispensed
water.
> On first using the appliance, and each time the
filter is changed, it is recommended to run water
through the circuit using the "Manual Cleaning"
function and to discard the ice produced over the
preceding 24 hours.
> If the water dispenser has not been used for at
least 4-5 days, it is recommended to rinse the circuit
by discarding the first litre of water dispensed.

2. INSTALLATION

> Reposition the removable water dispenser (where
present) only with clean hands.
>
Only use potable water to clean the ice cube tray
and container.
> The filter MUST be changed when indicated by the
control panel, or if the ice/water dispensing system
has not been used for at least 30 days.
> Each time the filter is changed, it is recommended
to disinfect he ice/water distribution system using
a food-safe disinfectant (e.g. sodium hypochlorite-
based products) which does not alter the
characteristics of the material. Rinse with at least 2
litres of water before use.
> Components of the ice and water distribution
system must only be replaced with original spare
parts supplied by the manufacturer.
> Repairs and maintenance must only be
performed by the manufacturer's technical support
department or by other qualified technicians.
2.1 Installation
Ensure that installation is performed correctly,
in full compliance with all instructions given in
centre about
the specific installation guide supplied with the
appliance.
2.2 Mains Water Connection
Models equipped with an ice maker require a
connection to the mains water supply.
This is performed using the new pipe with ¾"
thread supplied.
The mains supply pressure must be between 0.05
MPa and 0.5 MPa (0.5 bar to 5 bar).
Pressures outside of this range can lead to
malfunctions or leaks in the system.
www.universal.bertazzoni.com
Warning
The appliance MUST be plumbed in before
the electrical connections are made.
EN
5