Pfannenberg DTI Serie Manual De Instrucciones página 57

GB
DTI cooling unit switch cabinet assembly (installation)
Item Designation
1 Catch spring
3 DTI cooling unit
4 B Housing - cut-out
6 Switch cabinet wall / switch cabinet door
 The film for DTI cooling units with assembly instructions is available
Switch cabinet assembly
Requirements
- The cut-out for the DTI cooling unit has been made; see the figure
- The cooling unit is de-energized.
Required tools and material
- Assembly tool, fastening springs (2)/(5) (accessory kit)
Procedure
 Fit the cooling unit (3) in the cut-out from outside; see the figure DTI cooling unit assembly.
 Push the cooling unit (3) into the switch cabinet (6) until the unit seal is applied.
 The catch spring (1) on the top side of the unit audibly engages. The cooling unit (3) is now secured from falling
out.
 Engage the fastening springs (2)/(5) on the inside of the switch cabinet (6).
 Press the fastening springs in with your hand so that the retaining bracket engages in the housing cutout (4 A).
 Use the fastening springs in the rear housing cut-outs (4B) for switch cabinets with reinforcement frame.
 Mount the cooling unit (3) so that the emergency condensate drain is arranged at the bottom of the unit.
 The DTI cooling unit is attached to the switch cabinet and ready for electrical connection.
Operating Manual DTS and DTI 6401 / 6501 Standard Controller (SC) 086100007 © Pfannenberg GmbH
1
2
3
4 A
4 B
5
6
Figure12 – DTI cooling unit assembly
Item Designation
2 Fastening spring (top)
4 A Housing - cut-out
5 Fastening spring (bottom)
HERE.
DTI cooling unit assembly.
Page 19 / 38