Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPTIONAL:
if you connect the brown and black wires to
the control relays on your boiler, it will be switched off if the
water level rises too high in the unit.
ATTENTION:
The maximum current admissible for our
detection system is 0.5A.
To protect the electrical components in the
SANICONDENS
Pro, once the alarm has been triggered,
®
any water continuing to fill the tank comes out through the
overflow outlets in the cover.
7e
BEFORE TURNING THE DEVICE ON, MAKE
SURE YOU REMOVE THE PROTECTIVE LOCK PIN
FROM THE REAR OF THE DEVICE
7f
EXAMPLE OF AN INSTALLATION OF
A SANICONDENS
Pro: see fig.
®
8
STANDARDS
SANICONDENS
Pro conforms to the European directive
®
2006/95/CEE on electrical safety.
INSTRUCTIONS INTENDED SOLELY FOR
QUALIFIED PROFESSIONALS
9
DISASSEMBLY
If a breakdown occurs, any service on the unit should be
carried out by a qualified engineer. In particular the
replacement of the power cable.
Disconnect the electrical supply before carrying out
work on the unit.
7f
9
10
TROUBLESHOOTING
INSTRUCTIONS RESERVED SOLELY FOR
QUALIFIED PROFESSIONALS
Disconnect the electrical supply before carrying out any work.
FAULT DETECTED
PROBABLE CAUSES
• The pump does not start
• The pump is not
connected to the power
supply
• The lock pin has not
been removed.
• The unit is not level.
• Power cut
• Float blocked
• Condensates inlet pipe
blocked
• The pump does not lift
• Non-return valve blocked
• Discharge pipe blocked
11
WARNING
This device is not designed for persons (including children)
with limited physical, sensory or mental abilities, or those
with minimal experience and knowledge, unless they are
monitored and are given the necessary instructions for
using the device, with the help of a person responsible for
their safety. Monitor children and make sure they do not
play with the device.
12
GUARANTEE
SANICONDENS
Pro SFA is guaranteed for 2 years for
®
parts and labour, subject to correct installation and use of
the unit.
ACTION NEEDED
• Plug in the unit.
• Remove the lock pin.
• Please check the unit
with a spirit level.
• Check the mains voltage.
• Clean the SANICONDENS
®
Pro tank.
• Clean the SANICONDENS
®
Pro inlet pipe.
• Clean the valve.
• Clean the discharge pipe.
Tabla de contenido
