RIDGID R4122 Manual Del Operador página 18

ASSEMBLY
SQUARING THE BLADE TO THE FENCE
See Figures 17 - 23.
 Unplug the saw.
 Pull the saw arm all the way down and engage the lock
pin to hold the saw arm in transport position.
 Lift the miter lock lever, then depress and hold the detent
release button to release the miter table.
 Rotate the control arm until the scale indicator is
positioned at 0°.
 Release the detent release button, engaging the positive
stop notch, then push the miter lock lever down to secure
the miter table.
 Loosen bevel lock knob and set saw arm at 0° bevel
(blade set 90° to miter table). Tighten bevel lock knob.
 Lay a square flat on the miter table. Place one leg of the
square against the fence. Slide the other leg of the square
against the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
 The edge of the square and the saw blade should be
parallel as shown in figure 17.
 If the front or back edge of the saw blade angles away from
the square as shown in figures 18 and 19, adjustments
are needed.
SLIDING
MITER
FENCE
MITER
TABLE
VIEW OF BLADE SQUARE WITH FENCE
BLADE
MITER
SQUARE
LOCK LEVER
SLIDING
MITER
FENCE
BLADE
MITER
TABLE
VIEW OF BLADE NOT SQUARE WITH FENCE,
SLIDING
MITER
FENCE
VIEW OF BLADE NOT SQUARE WITH FENCE,
Fig. 17
18 - English
SQUARE
MITER LOCK
LEVER
ADJUSTMENTS ARE REQUIRED
BLADE
SQUARE
ADJUSTMENTS ARE REQUIRED
Fig. 18
MITER
TABLE
Fig. 19