Resources; Glossary Of Terms - Dremel Idea Builder 3D40 Instrucciones De Funcionamiento

DM 2610039151 01-16_3D40 1/7/16 9:33 AM Page 8
Resource
Quick Start
Guide
Dremel 3D
Website
Dremel 3D
Customer
Support
Print Studio
Software
Term
Build Platform
Build Platform Clip
Build Tape
Build Volume
Door
Ethernet Port
Extruder
Extruder Fan
Extruder Fan Baffle
Extruder Intake
Extruder Lever

Resources

Description
Provides illustrated walkthrough of
how to un-box your 3D40 and start
building out of the box.
Provides the latest 3D40 software,
product information, customer support,
and 3D model and project downloads.
Contact Dremel for product support,
maintenance, and service.
Allows you to upload, edit, and build
3D files.

Glossary of Terms

Definition
The flat surface used by your Dremel 3D40 to build objects. The build platform is
comprised of a tempered glass plate with a plastic holder.
Clip located at the front of the build platform base that is used to secure the build platform
in place.
Adhesive tape that improves the consistency of your objects and helps them stick to the
build plate surface.
The three dimensional (3D) amount of space that an object will use once it is completed.
Your Dremel 3D40 has a maximum build volume which means that objects with a larger
build volume cannot be built unless they are resized or broken into sub-objects.
Your Dremel 3D40 has a door located on the front panel. This allows for easy access to
the build platform, extruder, filament, and your objects. This door is made with a
transparent material so you can monitor the progress of your objects while keeping the
build environment stable.
A local area wired networking technology that allow electronic devices to communicate.
An assembly that uses gears to pull filament through the extruder intake, heat the filament
to the build temperature, and push the heated filament out of the extruder tip.
A fan used to cool the outer assembly of the extruder and gear motor.
A plastic piece that directs air from the extruder fan onto the build platform to assist in
cooling the active build.
An opening located at the top of the extruder where filament is inserted for building.
A lever located on the side of the extruder that is used to loosen the grip of the extruder
gear motor.
Printed version of the Quick Start
Guide is located in the rectangular
component carton. It is also
available on www.dremel3d.com
www.dremel3d.com
1-844-4DRML3D
(1-844-437-6533)
www.dremel3d.com
Installed from www.dremel3d.com
or from USB flash drive provided
with the Dremel 3D40.
8
Location