DM 2610039151 01-16_3D40 1/7/16 9:33 AM Page 26
PREPARING BUILD PLATFORM
Do not drop the build
platform. Tempered glass
WARNING
plate may break and result in personal injury.
Do not remove tempered
glass plate from plastic
WARNING
holder. Contacting with tempered glass plate
edge may result in personal injury.
Before every build make
sure that the build platform is
CAUTION
covered with Dremel specified build tape.
Use of improper build tape may result in
equipment damage and poor object build
quality.
1. If build platform is installed, remove by
pinching the clip located at the front of the
build platform and lifting the build platform
off the base, figure 3.
2. Remove adhesive liner from Build Tape
and place Build Tape over Build Platform.
For best results, apply Build Tape at
center of Build Platform first and smooth
outward to remove any air bubbles,
figure 4.
3. Install the build platform using the build
platform clips.
FIG. 3
LI FT
Build Tape
26
FIG. 4
Build
Platform