Removing Your Object - Dremel Idea Builder 3D40 Instrucciones De Funcionamiento

DM 2610039151 01-16_3D40 1/7/16 9:33 AM Page 31
REMOVING YOUR OBJECT FROM THE
BUILD PLATFORM
Do not touch the extruder
tip during Dremel 3D40
WARNING
operation or until it has cooled down to at
least 60°C (140°F). Contact with the extruder
tip during or after operation before tip has
cooled may result in personal injury.
Use personal protective
equipment. The use of
WARNING
protective equipment such as heat resistant
gloves and safety glasses will reduce
personal injuries.
Be aware of your body
position when using hand
WARNING
tools to remove objects from the build
platform. Sudden tool slip and improper
body position during object removal from the
build platform may result in personal injury.
Do not drop the build
platform. Tempered glass
WARNING
plate may break and result in personal injury.
Do not twist or bend the
build
WARNING
removing objects. Tempered glass plate
may separate from plastic holder and result
in personal injury.
Avoid scratching the build
platform when removing
CAUTION
objects. Scratches in the build platform will
result in improper object creation.
1. Wait for the extruder to cool before

removing your object.

2. With the object still attached, remove build
platform from the build area.
3. Peel your object from the build platform. If
needed, gently use the object removal tool
to remove object from build platform
(figure 8). If desired, remove the build tape
from the build platform while separating
the object from the build platform. The
build tape can then be removed from the
object.
Removing Your Object
platform while
31
Removal
Tool
REMOVING SUPPORTS
(IF REQUIRED)
Use needle nose pliers to remove supports
that are inside your object or hard to reach.
FIG. 8