Setting Manufacturer Codes - Yamaha RX-SL100RDS Manual De Instrucciones

Setting manufacturer codes

Once you set the appropriate manufacturer codes, you can
use this remote to control your other components. Note
that some buttons may not correctly operate the selected
component. Use the input selector buttons to select the
component you want to operate. The remote control
automatically switches to the appropriate control mode for
that component.
Default codes
The following table shows the default component
(Library: component category) and the manufacturer code
for each area.
Input area Manufacturer
TV (DTV/CBL)
VCR
DVD (DVD/CD)
Note
You may not be able to operate your YAMAHA component even
if a YAMAHA manufacturer code is initially set as listed above.
In this case, try to set another YAMAHA manufacturer code.
Setting a code
1
Hold down CODE SET while doing steps 2
and 3.
CODE SET
2
Press an input selector button to select the
source component you want to set up.
DVD/CD
DTV/CBL
Code
YAMAHA 299
YAMAHA 399
YAMAHA 699
VCR VIDEO 1
TUNER VIDEO 2
3
Press the numeric buttons to enter the three-
digit manufacturer code for the component
to be used, then release CODE SET.
HALL JAZZ
1 2
MUSIC TV THTR
5 6
NIGHT
q/DTS
9 0
Refer to "LIST OF MANUFACTURER CODES" at the
end of this manual.
y
To reset an input area's manufacturer code to the factory default,
input the default code (see "Default codes" above) in step 3.
Notes
• If the manufacturer of your component has more than one code,
try each of them until you find the correct one.
• If you wait for more than 10 seconds during step 3, the setup
process is canceled. If this happens, start over from step 2.
• Replace the batteries frequently. The settings may be lost after
two minutes without power supply.
REMOTE CONTROL FEATURES
ROCK ENTERTAIN
3 4
MOVIE 1 MOVIE 2
7 8
EX/ES STEREO
+10 ENT
EFFECT
47