To Remove The Cutting Deck - Husqvarna R 322TX AWD Manual Del Usuario

5. Put the drive belt as shown to make sure that it does
not get caught and break when the cutting deck is
attached.
6. Push the equipment frame down. Lift the service lock
to vertical position.
WARNING: The lock mechanism
can cause injury to fingers if you do
not operate it carefully. Put the
service lock in full vertical position
and hold the front edge of the
cutting deck with two hands when
you continue to the next step.
7. Lift the front edge of the cutting deck and move it
into the equipment frame. The plugs on the cutting
deck, one on each side, must be put in the grooves
on the equipment frame. The service lock releases
automatically.
A
849 - 004 - 21.10.2019
8. Lift the cutting height stay from the stay holder and
put it in the hole for the cutting height stay (A).
A
9. Put the drive belt around the tension wheel (B).
10. Put the spring in the spring holder (C).
11. Set the lift lever for the cutting deck in locked
position. The cutting deck lifts.
12. Attach the front cover.

To remove the cutting deck

To attach the cutting deck on page
1. Do steps 1–4 in
14 .
2. Release the clip on the front cover with the tool
attached to the ignition key, and remove the cover.
C
B
15