Dimmer Curves - Cameo MOVOBEAM ZOOM 100 Manual De Usuario

Operating status with DMX
DMX Fail =
Dimmer Curve =
Pan Rev =
Tilt Rev =
Feedback = Position correction
Fan Control =
Automatic blackout in the
Mov Blackout =
event of head movement
Correction of head position
Calibrate
TEST =
Reset =

DIMMER CURVES

linear
DMX value
DEVICE INFORMATION (System Info)
Press MODE to access the system settings selection menu. Now use UP and DOWN to select the menu item "System Info" (shaded in
colour) and confirm with ENTER. This will take you to the sub-menu for displaying the device information. Use UP and DOWN again to select
the required sub-menu item, then access the information with ENTER.
DMX 36 Ch DMX 36 Ch
ADDRESS 001 Software Ver
MODE xxx Temp info
Setting Time info
System Info
Hold
or
black-
signal fault
out,
Auto
Linear
Exp
Dimmer curve
Log
S Curve
Normal
Pan Reverse
Reverse = Reversal of pan direction
Normal
Tilt reverse
Reverse = Reversal of tilt direction
ON
OFF
Regular = Maximum brightness with normal fan function
Fan speed
Silent
ON
OFF
Pan
for pan and tilt
Tilt
OFF
Function test
ON
Pan &
Tilt
Reset
Head
All
exponential logarithmic
DMX value
DMX value
VR.xx
= Last command is retained
= Activates blackout
= Activates auto mode
= Light intensity increases linearly with DMX value
= Light intensity can be finely adjusted at lower DMX values and broadly
adjusted at higher DMX values
= Light intensity can be broadly adjusted at lower DMX values and finely
adjusted at higher DMX values
= Light intensity can be finely adjusted at lower and higher DMX values
and broadly adjusted at medium DMX values
= No reversal of pan direction
= No reversal of tilt direction
= Automatic position correction activated
= Automatic position correction deactivated
= If necessary, reduced brightness with quiet fan
= Blackout in the event of head movement
= No blackout in the event of head movement
Position correction from -128 to +127
Position correction from -128 to +127
= Stop function test
= Step-by-step function test of LEDs and motors (approx. 30 seconds)
Reset pan and tilt motors
= Reset the device head
= Reset all motors and settings
S-curve
DMX value
9