Radio Reception - Sony DSX-A510BD Manual De Instrucciones

No beep sound.
 An optional power amplifier is connected and
you are not using the built-in amplifier.
The contents of the memory have been erased.
 The power supply lead or battery has been
disconnected or not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes a noise when the position of the ignition
is switched.
 The leads are not matched correctly with the car's
accessory power connector.
During playback or reception, the demonstration
mode starts.
 If no operation is performed for 5 minutes with
[DEMO-ON] set, the demonstration mode starts.
 Set [DEMO-OFF] (page 20).
The display disappears from/does not appear in
the display window.
 The dimmer is set to [DIM-ON] (page 22).
 The display disappears if you press and hold OFF.
 Press OFF on the unit until the display appears.
 The connectors are dirty (page 24).
The display/illumination flashes.
 The power supply is not sufficient.
 Check that the car battery supplies enough
power to the unit. (The power requirement is
12 V DC.)
The operation buttons do not function.
 Press DSPL and
(back)/MODE for more than
2 seconds to reset the unit.
The contents stored in memory are erased.
For your safety, do not reset the unit while you
are driving.
The clock set automatically is not accurate.
 The clock data on radio waves is not accurate.
 Set the clock manually (page 7).

Radio reception

The radio reception is poor.
Static noise occurs.
 Connect the antenna (aerial) firmly.
DAB/DAB+ radio reception
DAB stations cannot be received.
 See [NO STATION] (page 31) for details.
No traffic announcements.
 Disable DAB announcements (page 11).
 Traffic announcements are disabled while DAB
announcements are enabled.
RDS
The SEEK starts after a few seconds of listening.
 The station is non-TP or has weak signal.
 Deactivate TA (page 12).
No traffic announcements.
 Activate TA (page 12).
 The station does not broadcast any traffic
announcements despite being TP.
 Tune in another station.
PTY displays [- - - - - - - -].
 The current station is not an RDS station.
 RDS data has not been received.
 The station does not specify the program type.
Program station name flashes.
 There is no alternative frequency for the current
station.
 Press / (SEEK –/+) while the program
station name is flashing. [PI SEEK] appears and
the unit starts searching for another frequency
with the same PI (program identification) data.
27
GB