Bosch GLM 50 C Instrucciones De Funcionamiento página 28

rect length
pear in the status bar. Press the measure button 2 [ ]
to select double indirect length measurement.
16'11"
0.0°
60.0°
16'09" ⁄
e. The measuring values for the distances A and the
angle C at which you took the measurement will dis-
play in the measured-value lines d.
Wall Surface Measurement
The wall surface measurement is used to determine
the sum of several individual surfaces which all have
same height. This function can be useful if you were
trying to determine the surface area of many walls to
be painted in order to know how much paint to buy.
In the example shown in figure E, the total surface of
several walls that have the same room height H, but
different lengths L, are to be determined.
Press the function button 7 [Func] and use the plus
button 3 [ ] or minus button 8 [ ] to cycle through
the measurement functions until the highlighted
square appears over the indicator for wall surface
measurement
in the status bar. Press the measure button 2 [ ] to
select Wall Surface Measurement. Press the measure
button 2 [ ] to activate the laser.
21'02"
H
0.0° Σ
55'01"
L
29'07" L
1167.0ft
and the words "Indirect Length" ap-
Press the measure button 2 [ ] to ac-
tivate the laser. Tilt the laser measure
while keeping the base of the laser
⅜
measure stable and point the laser on
a diagonal at the object you wish to
measure to. Press the measure but-
ton 2 [ ] to take the measurement A.
The desired indirect length measure-
ment X will display in the result line
and the words "Wall Area" appear
Place the laser measure on the floor
and aim the laser at the ceiling, then
press the measure button 2 [ ] to
⁄
measure the room height H.
measured value is displayed in the
⁄
top measured-value line d. The laser
2
remains active.
(see figure E)
-28-
The