Bosch GLM 50 C Instrucciones De Funcionamiento página 26

Indirect Measurement
Indirect Height
Note: Indirect measurement is always less accurate
than length measurement or real time measurement.
Depending on the application, greater measuring er-
rors are possible than with length measurement or real
time measurement. To improve the measuring accu-
racy, we recommend using a tripod (accessory).
a. Indirect height measurement
Press the function button 7 [Func] and use the plus
button 3 [ ] or minus button 8 [ ] to cycle through
the measurement functions until the highlighted
square appears over the indicator for indirect mea-
surement
status bar. Press the measure button 2 [ ]. Press
the plus button 3 [ ] or minus button 8 [ ] to cycle
through the indirect measurement functions until the
highlighted square appears over the indicator for indi-
rect height
pear in the status bar. Press the measure button 2 [ ]
to select indirect height measurement.
38'01"
0.0°
45.0°
5'05" ⅓
The measuring values for the distance A and the angle
For indirect measurement, three mea-
suring modes are available. Each mea-
suring mode can be used for determin-
ing distances.
The indirect measurement is used
to measure distances that cannot be
measured directly because an obstacle
is obstructing the laser beam or no tar-
get surface is available as a reflector.
and the word "Indirect" appears in the
and the words "Indirect Height" ap-
Press the measure button 2 [ ] to ac-
tivate the laser. Tilt the laser measure
while keeping the base of the laser
⅝
measure stable and point the laser at
the height of the object you wish to
measure. Press the measure button 2
[ ] to take your measurement.
The desired indirect height measure-
ment X will display in the result line e.
(see figure B)
-26-