Installing The Shoulder Strap; Control Panel - Panasonic EY7880 Manual De Instrucciones

Depth gauge

Installing the Shoulder Strap

CAUTION:
• Install the shoulder strap firmly to
the main unit of the tool and check
the length of the strap before use.
• Check the condition of the strap
and do not use if it is cut or torn etc.
There is a risk of injury or damage
if used while improperly installed.
• Please wear the shoulder strap se-
curely on the shoulder.
There is a risk of injury or damage
if it is accidentally dropped.
1. Pass the strap through the strap
holders.
2. Pass the strap through the buckles
and adjust the length.
Shoulder pad
Follow the instructions below in order
to avoid injury.
• The shoulder strap can be adjusted
according to the individual.
• Adjust the shoulder pad to the shoulder.
• Pull the shoulder strap to make sure it is
firmly attached to the main unit of the tool.

Control panel

(1)
(2)
Depth of drilling
(3)
- 8 -
(1) Battery low warning lamp
Off (normal
operation)
Excessive (complete) discharging of Li-
ion batteries shortens their service life
dramatically. The driver includes a battery
protection feature designed to prevent
excessive discharging of the battery pack.
• The battery protection feature ac-
tivates immediately before the bat-
tery loses its charge, causing the
battery low warning lamp to flash.
• If you notice the battery low warn-
ing lamp flashing, charge the bat-
tery pack immediately.
(2) Overheat warning lamp
Off (normal
operation)
The overheating protection feature
halts driver operation to protect the
motor and battery pack in the event
of overheating. The overheat warning
lamp on the control panel flashes
when this feature is active.
• If the overheating protection feature
activates, allow the driver to cool
thoroughly (at least 30 minutes).
The driver is ready for use when the
overheat warning lamp goes out.
• Avoid using the driver in a way that
causes the overheating protection
feature to activate repeatedly.
NOTE:
• In summer or in other situations
where the temperature is high, the
overheating protection feature may
activate and prevent continual use.
Flashing (No charge)
Battery protection
feature active.
Flashing: Overheat
Indicates operation has
been halted due to motor
or battery overheating.