Transporting The Machine - Stihl SP 200 Manual De Instrucciones

If the engine does not start
Choke knob
If you did not turn the choke knob to e
quickly enough after the engine began to
fire, the combustion chamber has
flooded.
Turn the choke knob to e
:
: Set slide control, interlock lever and
throttle trigger to starting throttle
position.
: Start the engine by pulling the
starter rope firmly. 10 to 20 pulls
may be necessary.
If the engine still does not start
10
: Push the slide control to STOP-O
: Pull off the spark plug boot (10).
SP 200
: Open the throttle wide.
: Crank the engine several times with
the starter to clear the combustion
chamber.
: Refit the spark plug and connect the
spark plug boot – push it down
firmly.
: Set the slide control to START
: Set choke knob to e – even if
engine is cold.
: Now start the engine.
Throttle cable adjustment
: Check adjustment of throttle cable –
see "Adjusting the Throttle Cable".
Fuel tank run until dry
: After refueling, press the fuel pump
bulb at least five times – even if
bulb is still filled with fuel.
: Set choke knob according to engine
temperature.
: Now start the engine.
English / USA

Transporting the Machine

The split drive tube enables the machine
to be disassembled for easier
transportation.
Separating the Drive Tubes
: Disconnect the harness from the
carrying rings.
: Place the machine on the ground so
that it rests on the engine support
and the hook.
: Turn the hook so that its open side
points vertically downward.
23