Waeco PerfectView CAM24 Instrucciones De Montaje página 26

Safety and installation instructions
Observe the following installation instructions:
z Secure the parts of the camera installed in the vehicle in such a way that
they cannot become loose under any circumstances (sudden braking, ac-
cidents) and cause injuries to the occupants of the vehicle.
z Secure any parts of the system covered by the bodywork in such
a manner that they cannot be come loose or damage other parts
and cables and impair vehicle functions (steering, pedals, etc.).
z To prevent damage, when drilling ensure that there is sufficient room
for the drill head to come out on the other side (Fig. 2, page 4).
z Deburr all drill holes and treat them with a rust-protection agent.
z Always follow the safety instructions of the vehicle manufacturer.
Some work (e.g. on retention systems such as the AIRBAG etc.)
may only be performed by qualified specialists.
Observe the following instructions when working with electrical parts:
z When testing the voltage in electrical cables, only use a diode test lamp
(Fig. 1 8, page 3) or a voltmeter (Fig. 1 9, page 3).
Test lamps with an illuminant (Fig. 1 12, page 3) take up voltages which
are too high and which can damage the vehicle's electronic system.
z When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection
(see Fig. 3, page 4)
z Insulate all connections.
z Secure the cables against mechanical wear with cable binders or
insulating tape, for example to existing cables.
The camera is watertight. However, the sealings on the camera cannot
withstand a high-pressure cleaner (Fig. 4, page 4). Therefore, you should
observe the following instructions when handling the camera:
z Do not open the camera, as this impairs the sealing and the function of
the camera (Fig. 5, page 4).
z Do not pull at the cables, as this impairs the sealing and the function of
the camera (Fig. 6, page 4).
z The camera is not suitable for submerged operation (Fig. 7, page 4).
26
PerfectView CAM24, CAM27