Tabla de contenido
Idiomas disponibles
Idiomas disponibles
A
B
C
Display
Battery indication lamp
3. Press the
and
clutch setting that is appropriate for the
work being performed.
As the
button
is pressed
78
79
77
OK button
D
EYFA31
buttons to select the
As the
button
is pressed
80
15
16
...
17
RPM
80
800
75
750
45
450
15
150
4. Press the OK button to accept the select-
ed speed adjustment setting.
• The control panel will stop flashing and
light up.
CAUTION:
• You must press the OK button in order
for the selected setting to take effect.
• Be sure to verify the new value after
changing the setting. (See page 13.)
Auto downshift function
• By having the tool operate at high speed
at the start of the tightening process then
shifting to low speed operation just before
the tightener becomes flush the auto
downshift function increases tightening
speed while maintaining accuracy. When
Auto Downshift is enabled it downshifts
to a low speed of 300 RPM at the time
programmed with the remote control.
1. Set the tool to setting configuration mode.
(See page 10.)
. Press the D button twice.
• The auto downshift function setting value
will be displayed.
3. Press the
time as desired.
Operation
4. Press the OK button to accept the new
setting.
NOTE:
• The speed at the start of tightening
operation is set with the speed adjust-
ment function.
- 11 -
GA1
GA
Setting not
available
Setting
available
and
buttons to change the
Display
Seconds
30
3 seconds
1
0.1 seconds
0
OFF
GA3
Tabla de contenido
