Attaching The Non-Skid Pads; Part Names And Functions; Overview Of The Main Unit - Pioneer X-EM26 Manual De Instrucciones

CAUTION
• When inserting the battery, make sure not to damage
the spring on the battery's - terminal. This can cause
the battery to leak or overheat.
Insert the battery by
aligning the pole
-
against the remote
control's terminal
-
• Do not use any battery other than the one specified.
• When loading the battery into the remote control, set it
in the proper direction, as indicated by the polarity
marks (+ and -).
• Do not heat the battery, disassemble it, or throw it into
flames or water.
• To prevent leakage of battery fluid, remove the battery
if you do not plan to use the remote control for a long
period of time (1 month or more). If the fluid should leak,
wipe it carefully off the inside of the case, then insert a
new battery. If a battery should leak and the fluid should
get on your skin, flush it off with large quantities of
water.
• When disposing of a used battery, please comply with
governmental regulations or environmental public
institution's rules that apply in your country/area.
• WARNING
Do not use or store batteries in direct sunlight or other
excessively hot place, such as inside a car or near a
heater. This can cause batteries to leak, overheat,
explode or catch fire. It can also reduce the life or
performance of batteries.

∫ Attaching the Non-skid pads

Apply the accessory non-skid pads to the bottom surfaces of
the speakers.
• Use the speaker is usually in an upright position.
Attach the non-skid pads to the bottom surface of the speakers.
If a battery pushes and
bends the terminal
-
out of shape, there is
possibility of the alkaline
battery shorting out
The terminal is bent
-
out of shape
The bottom surface of
the speaker
Part names and
functions

Overview of the main unit

1 2 3
4 5 6 7
1
Í
• Switch between standby and on.
2 Remote control sensor
• Point the remote control to this, and then operate it
within approximately 7 m. The product may have
trouble capturing remote control signals if there is a
fluorescent light nearby. If this happens, move the
product away from the fluorescent light.
3 Main display
4 Bluetooth indicator (X-EM26 only)
5
• Connect to a USB storage device.
6 Disc tray
• Place the disc with the label side up.
7 INPUT
• Press repeatedly to select the input source.
8
:6
• Skip to the previous track.
• Press and hold to play reverse quickly within a track.
• Tune to the previous radio station.
• Select a preset radio station.
9 59
• Skip to the next track.
• Press and hold to play forward quickly within a track.
• Tune to the next radio station.
• Select a preset radio station.
10 ∫
• Use to stop playback.
11 I
• Use to play, pause, or resume playback.
12 <
• Open or close the disc tray.
13 VOLUME
• Rotate to increase or decrease the volume level.
8 9 10 11 12 13
7
En